金型部

2018/6/13-16
We exhibited our products at INTERMOLD NAGOYA.

2017/8
We started mass-producing of large-size MulticolorMultiple and Decoration Molding.

2016/11/25
We did a presentation about the example of the plastic molding development at The Japan Fluid Power System Society.

2013/11/10
We were taken up in the "Gekkan Kanagata Shinbun" newspaper.

2013/10
We were installed a new molding machine "KS-2C1200E" in our factory.



We can meke an idea form---

Our products' quality is based on the collaboration of

excellent craftsmanships and high-tech equipments.


 MulticolorMultipleMolding

Name 3C Lamp shade
Molding 3 colors

Name Door of dryer
Molding 2 colors

Name Tail lamp
Molding 2・3 colors

Name Cleaner case
Molding 2 colors

Name Timing belt cover
Molding 2 colors

Name Ornamental Panel
Molding 2 colors




 MultidimensionalNCBlowMolding


Name Air duct

Name  Exhaust pipe
Name Fuel pipe




 HotFlowStampMolding


Name Back Door

Name Door trim upper




Encap Molding


Name Sun roof

Name Quarter window

Name Quarter window

Name Back window

Name Quarter window

Name Quarter window

Name Quarter window

Name Quarter window

Name Quarter window




 Others


Name Cowl

Name Fender

Name Shroud/duct

Name Quarter Pillar

Name Trunk side

Name Center pillar upper

Name Center pillar lower

Name Tail gate