精機部

2018/6/13-16
We exhibited our products at INTERMOLD NAGOYA.

2017/8
We started mass-producing of large-size MulticolorMultiple and Decoration Molding.

2016/11/25
We did a presentation about the example of the plastic molding development at The Japan Fluid Power System Society.

2013/11/10
We were taken up in the "Gekkan Kanagata Shinbun" newspaper.

2013/10
We were installed a new molding machine "KS-2C1200E" in our factory.

  • Clamp force to need of two color multiple material molding machine with face-to-face type is half as much as that of usual vertical rotation type.
    At first, we manufactured two color multiple material molding machine with vertical rotation type, and then we developed face-to-face type based on our rich experiment.
  • Rotation functions can be stopped at a 90 degree angle allowing insertion or hot stamping to be performed easily in the position.
  • If 2 normal metal molds are attached on both the left and on the right, and molding perfomed with the rotation functions turned off, it will do the work of 2 normal molding machine.