精機部

2018/6/13-16
We exhibited our products at INTERMOLD NAGOYA.

2017/8
We started mass-producing of large-size MulticolorMultiple and Decoration Molding.

2016/11/25
We did a presentation about the example of the plastic molding development at The Japan Fluid Power System Society.

2013/11/10
We were taken up in the "Gekkan Kanagata Shinbun" newspaper.

2013/10
We were installed a new molding machine "KS-2C1200E" in our factory.

Movie ... Under Construction
  • This process cased on compression molding technique, that is, a polymer that has been plasticized by the extruder is distributed on the lower mold by computer control,and then the press is closed and the product molded.
  • The clamping force of machine is sufficient at about 30% of that of injection. The price of the mold is lower than that for injection. Therefore, this molding is especially suited to small-scale production.
  • For this molding, it is possible to mold thin parts and less distortion.
  • This system need not any gates, so the loss of the material is not generated.
  • In-mold facric lamination is also possible by this molding.
  • It is possible to use high molecular weight resin(HDPE, PP, etc) or its reinforced composite resin, so the product has very useful properties such as high impact strength and long life.
  • It is possible to correspond to Injection and Compression Molding with exchanging the nozzle heads.